Lumitek Down Light Aluminum 3W 3000K (Warm White) S-DJ65

1200*600*32mm
1. Input voltage: AC90-265V
2. SMD2835
3. CRI: >80Ra
4. Power 56W
5. LED Life Span: >50000 Hours
6. Beam Angle: 120
7. CCT: 6500K
8. Outline Border: White
9. PF>0.9
10.PS Diffuser
11. Philips LED Chips

98mm
1. Input voltage: AC90-265V
2. Power 3W
3. CCT: 4000K
4. Outline Border: White
5. Installation: Recessed
6. Philips LED Chips

Specifications:

Cap-Base: G5 (G5)
EU RoHS compliant: Yes
Nominal Lifetime (Nom): 50000h
Switching cycle: 50000X

98mm
1. Input voltage: AC90-265V
2. Power 3W
3. CCT: 3000K
4. Outline Border: White
5. Installation: Recessed
6. Philips LED Chips

145mm
1. Input voltage: AC90-265V
2. Power 6W
3. CCT: 3000K
4. Outline Border: White
5. Installation: Recessed
6. Philips LED Chips

1200*300*32mm
1. Input voltage: AC90-265V
2. SMD2835
3. CRI: >80Ra
4. Power 40W
5. LED Life Span: >50000 Hours
6. Beam Angle: 120
7. CCT: 6500K
8. Outline Border: White
9. PF>0.9
10.PS Diffuser
11.Philips LED Chips

LU-CM6060 1200 x 300 x 32mm Surface Mounted Panel Frame Aluminum

Overview:

Osram LED T8 SubstiTUBE Value 2ft in 4000K (840) for EMag/Mains, is an economic LED tube for electromagnetic control gears or direct wire to Mains. A quick, simple and safe replacement without rewiring (comes with jumper starter), offering energy savings of up to 65% (compared to T8 fluorescent lamp on CCG), with a wide 220 beam angle, and a luminous efficacy up to 105 lm/W. These tubes provide Instant-on light, therefore ideally suitable in combination with sensor technology. Very high resistance to switching loads. Also suitable for operation at low temperatures (from -20 to 45). Not suitable for operation with electronic/HF control gear.

Specifications:

Cap-Base: G5 (G5)
EU RoHS compliant: Yes
Nominal Lifetime (Nom): 50000h
Switching cycle: 50000X

LU-CM6060 600 x 600mm Surface Mounted Frame Aluminum

This is a Osram LEDvance 4ft 1200mm 16.4w LED T8 Tube with a frosted finish.
These tubes are a direct retrofit for old 36w T8 or 40w T12 fluorescent tubes in switch start fittings as they come complete with a Free LED Starter. All you need to do is simply remove the old tube and starter and replace with the LED tube and starter supplied. They can also be used in high frequency fittings, by bypassing the control gear and wiring the fitting live and neutral to one end only.

595*595*32mm
1. Input voltage: AC90-265V
2. SMD2835
3. CRI: >80Ra
4. Power 40W
5. LED Life Span: >50000 Hours
6. Beam Angle: 120
7. CCT: 3000K
8. Outline Border: White
9. PF>0.9
10.PS Diffuser
11. Philips LED Chips